Tumblelog by Soup.io
Newer posts are loading.
You are at the newest post.
Click here to check if anything new just came in.
espowuriah

when using the biometric time clock adjust

3, when using the biometric time clock adjust, as far as possible large area contact fingerprint acquisition window, gently press, see monitor prompt information, prompt attendance success to move the fingers. 4, if prompt not correct or screen didn't respond, please take off your fingers, then to press. Don't put your fingers have been fingerprint acquisition window. If you use three times still tip is not correct or screen didn't respond, please contact with administrator in time, cutting error to roll machine for any operation. 5, do not force press fingerprint acquisition window, don't use nail or other objects scratch fingerprint acquisition window. Please ensure that the fingerprint acquisition window cleaning, completes the dustproof, waterproof, prevent oil pollution work. 6, please ensure that the fingerprint attendance machine use environment, don't place it in the cold, damp, high temperature environment. 7, please do not malicious damage attendance equipment.


7.Underground radio frequency biometric time clock  use note 1, before use, please to management department filing, receive and installed radio frequency card. 2, under the well please go under the provisions of the well attendance channel, the well please walk on the provisions of the well attendance channel. 3, when using please click order loop through attendance area, avoid many people together through the attendance area caused confusion, leakage knowledge, mutual interference. 4, through the check on work attendance equipment please make a little pause, as far as possible with card burner near the attendance machine, but don't touch roll machine.

5, when installing the buzzer on... long-short-long-short...) "di" sound, yellow light on fingerprint time clock success, forward leave attendance area. Attendance also can be observed on the attendance machine black traffic light hint, confirm attendance success, when the green light attendance success. 6, if buzzer appear ChangMing, yellow light does not work, or roll machine on the traffic lights without any response, please exit attendance area to enter or will lamp holder in the roll machine before the shaking. If repeated three times still is not successful, please contact with administrator in time, cutting error to roll machine for any operation. 7, please don't use lamp holder and lamp cap touch roll machine. 8, please don't carry metal objects through the attendance area, so as to avoid the interference. 9, please do not malicious damage attendance equipment.

8... How to use the fingerprint time clock? 1, roll machine can't communicate with computer? First check the COM and WangKou whether meet good, then check roll machine Settings: press "MENU" in the "Settings" - > "system Settings" Richard see roll machine appointed number (defaults to 1), baud rate (default 38400). Check the computer and software Settings: computer COM1 mouth wave Special rate (the default 38400), software Settings as shown in the software to help. 2, roll machine communication connection appear "didi" calls what reason be? (1) use RS - 232 communication if appear the above phenomenon, it is the computer baud rate and remote baud rate setting is consistent. (2) if use RS - 485 communication, it may be converter communication line two thread joint back, or is two lines sticking together.

Don't be the product, buy the product!

Schweinderl